AURA SSD FOR MAC BOOK PRO INSTALL HOW TO
AURA SSD FOR MAC BOOK PRO INSTALL INSTALL
AURA SSD FOR MAC BOOK PRO INSTALL DRIVER
AURA SSD FOR MAC BOOK PRO INSTALL UPGRADE
AURA SSD FOR MAC BOOK PRO INSTALL FULL

The installation video indicates that should be done using a nylon pry tool, which it assumes is part of install kit. Once the bottom plate has been removed, carefully remove the tab that covers the battery plate, and use your finger tip or a soft pry tool to disconnect the battery plug. As they are removed, separate each screw by group and remember that each must be reinstalled in the specific hole from which it originated. Secondly, the bottom plate of the MBPr come in three different lengths. The Pentalobe screwdriver is specially designed to work with these screw heads, and care should be taken not to strip any of the heads when removing them or screwing them back in. First, carefully remove each of the screws. Using the supplied Pentalobe screw driver, carefully remove each of the ten (10) screws holding the back plate.

It consists of unplugging the MBPr and situating it on a soft surface with the back cover facing up. The process should take less than twenty minutes to complete.

Both are sufficiently detailed to guide the process from start to finish. OWC hosts two installation videos at its website that demonstrate the process for replacing the Apple drive ( ) and installing it in the external Envoy case ( ). The companion Torx T-5 screwdriver is used to remove the screw that secures the MacBook Pro’s internal Apple SSD drive.

AURA SSD FOR MAC BOOK PRO INSTALL DRIVER

The Pentalobe screw driver is specifically designed to remove the screws that secure the rear case of the MBPr. OWC’s kit consists of the Aura Pro 6G SSD, USB 3.0 bus-powered enclosure, carrying case, cable, installation manual, and two otherwise hard-to-find screwdrivers. The process is straightforward, relatively simple, and all tools required to remove and install the drives are supplied with the kit.

AURA SSD FOR MAC BOOK PRO INSTALL HOW TO

This article recounts how to remove the Apple internal SSD drive in the MBPr, replace it with OWC’s 480GB Aura Pro 6G SSD, and install the Apple SSD in the Envoy Pro external USB 3.0 case. The OWC 480GB Aura Pro 6G was reviewed earlier this summer when it was tested for transfer speeds, build quality, and performance characteristics. This solution provides a faster internal SSD drive and a repurposed Apple SSD housed in a well-designed bus-powered USB 3 enclosure.

AURA SSD FOR MAC BOOK PRO INSTALL UPGRADE

The SSD and kit ships with the necessary tools to complete the upgrade process. Other World Computing’s Envoy Pro SSD and USB 3.0 external drive enclosure is a unique dual-purposed upgrade for 2012 and early 2013 MacBook Pros with retina displays. Solid State Drive and Envoy Pro Storage Solutionįor 2012-Early 2013 MacBook Pro with Retina Display We'll detail the process we used, noting a couple caveats along the way.How To Upgrade Your Retina MacBook Pro With OWC’s It's not difficult at all, but it can be more time-consuming than one would hope.

AURA SSD FOR MAC BOOK PRO INSTALL FULL

OWC told Ars that it plans to offer an external USB enclosure sometime soon, but until then, replacing the SSD means a full backup and restore to an external drive will be needed. With standard 2.5' notebook drives, you could put the original in an external case, install the replacement, and clone the external drive to the new drive. The main hurdle with installation was that there were no external drive cases for the special small-outline SSD modules that Apple uses in the MacBook Air. Depending on your comfort level, you should be able to do it in 15-20 minutes. The installation process for the drive itself is very straightforward: remove some screws, remove the bottom plate, take out the OEM SSD, swap in the OWC SSD, and put the bottom plate back on. Everything else is soldered directly to the logic board, including the RAM. The battery can technically be swapped out too, but so far, the only parts are available directly from Apple, which means a trip to the Genius Bar. Installation: pentalobe driver includedĪs we said earlier, the SSD is pretty much the only user-serviceable part inside the latest MacBook Air. So we installed a 240GB Mercury Aura Pro Express that the company lent us into an 11' MacBook Air in order to see how difficult the upgrade process is, and to put the drive through its paces and see what kind of performance gains are possible with the Sandforce-based design. OWC's Mercury Aura Pro Express SSDs (say that three times fast) come in 180GB, 240GB, 360GB, and 480GB capacities. It took a few months, but long-time Mac upgrade source Other World Computing stepped up to offer three upgrade options based on fast Sandforce controllers. The SSDs have so far only been available to OEMs directly from Toshiba, despite the fact that the SSD is the only user-replaceable part in the MacBook Air. Apple launched updated MacBook Air models in October of 2010, featuring new, compact, and (originally) proprietary form-factor solid state drives (SSDs).

Aura ssd for mac book pro install